Fueltech PEAK & HOLD 8A/2A DRIVER 3010003325

**Free Shipping on all orders over $200 to lower 48 states**

We Cannot Ship Any Performance Item that Effects the Vehicles Emissions to CA or Carb States that isn’t Carb Approved

Warning: This Product can expose you to chemicals including lead, chromium (hexavalent compounds) and benzene which are known to the State of California to cause cancer and birth defects, or other reproductive harm ( For More information go to www.p65warnings.ca.gov )

Fueltech PEAK & HOLD 8A/2A DRIVER 3010003325

FEATURES

• Current control driver for low impedance injectors
• 4 channels
• Available in three current versions:
  8A/2A 
  4A/1A
  2A/0.5A

TECHNICAL DESCRIPTION

Peak and Hold 8A/2A

• Controls up to 4 injectors with impedance below 1.5 ohm
• 16 Bosch 160lb/h (1600cc) injectors (4 per channel)
• 8 Siemens low impedance injectors (2 per channel)
• 4 MSD low impedance injectors (2 per channel) (with 2 ohms impedance per injector)

Peak and Hold 4A/1A

• Controls up to 4 injectors with 1.5 to 3 ohms of impedance
• 8 Bosch 160lb/h (1600cc) injectors (2 per channel)
• 4 Siemens 83lb/h injectors
• 4 MSD injectors (with 2 ohms impedance per injector)

Peak and Hold 2A/0.5A

• Controls up to 4 injectors with 3 to 7 ohms of impedance
• 4 Bosch 160lb/h (1600cc) injectors

Dimensions: 115 x 90 x 33mm

TO DETERMINE WHICH PEAK & HOLD YOU NEED

1. Grab a multi-meter and select Ohms 200
2. Touch the positive and negative leads of multi-meter together to measure resistance (record this number...i.e. measured 0.3)
3. Then take the positive and negative leads from multi-meter and put on each terminal of the injector. Doesn't matter the order. Record this measurement
4. Take the ohms measurement from Step 3 and then subtract the number you got in Step 2 (i.e. Step 3 4.8ohms - Step 2 0.3ohms = Total 4.5ohms)

High Impedance Injectors - Above 7ohms - No Peak and Hold Boxes are needed.
Peak and Hold 2A - 3ohms to 7ohms (Bosch 160lb/hr).
Peak and Hold 4A - Below 3ohms to 1.5ohms.
Peak and Hold 8A - Below 1.5ohms (Billet Atomizer*).
All low impedance Billet Atomizer Injectors manufactured after Nov. 2012 require 8A regardless of measured resistance.

*Billet Atomizer Injectors - Anything prior to serial # C300**** should only use the 4A/1A. This only applies to injectors manufactured prior to Nov. 2012.

CONTENTS OF PACKAGING

• 1 Peak and Hold 8A/2A
• 1 Operation and installation guide
• 1 mounting kit (4 rubber mounts, 4 washers and 4 ¼” nuts)
• 6ft Peak and Hold unterminated harness (optional)
• 1 FuelTech black carbon fiber sticker